App guide

How to use
DepthScan

Screen-by-screen walkthrough of the iOS app — from laying the phone down to exporting the mesh. UI frames match the live ScanView flow.

UI mocks from the current app screens · replace with device photos when available

Before you start

DepthScan needs a TrueDepth iPhone and a few ordinary magnets. If you sideloaded the beta, trust the developer profile first.

Hardware

iPhone 12 Pro or later · 2–3 small magnets · flat desk · part roughly 2–15 cm

Install / trust

Developer Mode on + restart, then Settings → General → VPN & Device Management → Trust the DepthScan developer. Full install steps: Try the beta.

Permissions

Allow Camera and Motion when prompted — TrueDepth + magnetometer won’t start without them.

01 / PLACE

Lay the phone face-up

Open DepthScan and put the phone flat on the table, screen facing up. Keep it still — CoreMotion waits until the device is level and steady.

📱
Place phone face-up
on a flat surface
Hold it still once it's down
WaitingForTableView
02 / MAGNETS

Stick 2–3 magnets on the part

When the phone is steady, DepthScan asks you to attach magnets. Spread them out — not in a straight line — so rotation can be solved uniquely.

Tip: different sizes help, but aren’t required.

⠿
Stick 3 magnets on your part, spread out and not in a straight line.
Use 2–3 small magnets (stickers work). Spread them out — avoid placing them in a straight line.
Magnets attached
Skip — track rotation visually instead
Calibration · instructions
03 / BASELINE

Capture the Earth baseline

Move the part away for a moment so the magnetometer reads ambient field with no magnets nearby. The app does this automatically after you confirm magnets are attached.

◌
Move the part away from the phone for a moment…
Capturing Earth baseline
Calibration · capturingBaseline
04 / POSES

Hold 6 reference poses

Rotate the part to clearly different angles. At each pose, hold steady and tap Capture pose. TrueDepth supplies orientation ground truth while the magnetometer records the field.

Pose 2 of 6
Hold the part steady in pose 2 of 6, then tap Capture.
Capture pose
Calibration · awaitingPose
05 / SCAN

Hold the part above the screen

After calibration, the live mesh builds on screen. Hold the part in the TrueDepth beam and rotate slowly. Hands can stay in frame — Vision masks them out.

SCANNING
Rotate the part slowly above the screen
12.4k pts 87% track
+ Add another phone Join a session
ScanningView
06 / REVIEW

Review coverage

When coverage looks solid, DepthScan offers to finish or keep scanning. Magnets leave tiny shadows — you can relocate them for a second pass, or finish now.

Coverage: 91%
Looks good. You can finish now or keep scanning to fill any gaps.
The magnets covered a few small spots while scanning.
Move magnets & fill gaps
Keep scanning Finish
ReviewCoverageView
07 / FILL GAPS

Move magnets, scan again

Optional but recommended. Move the magnets to new spots (still spread out), tap I moved them, hold still while DepthScan confirms, then rotate again under FILLING GAPS.

↻
Move the magnets to new spots on the part
Keep them spread out and not in a line — exact placement doesn't matter.
I moved them
Skip — finish without filling gaps
RelocateMagnetsView
08 / EXPORT

Build the final mesh

DepthScan runs Object Capture on the saved frames and writes the mesh. When done you’ll see Scan complete — start a new scan anytime.

✓
Scan complete
Saved to DepthScanMesh.usdz
New scan
CompleteView

Ready to scan?

Install the beta, trust the developer, then follow the steps above.

Try the app (beta) → See pricing Product overview